Safety Instructions And Precautions - Salda RIS 700 H EKO 3.0 Mounting And Installation Instruction

3. SAFETY INSTRUCTIONS AND PRECAUTIONS

Read these instructions very carefully before installing and using this equipment. Installation, connection and maintenance should be carried out
by a qualified technician and in accordance with local regulations and legislation.
The company shall take no responsibility for the injuries or damaged property if the safety requirements are not followed or the device is modified
without the permission of the manufacturer.
Main safety rules
Danger
• Before carrying out any electrical or maintenance works, make sure that the device is disconnected from the mains and that all moving
parts of the device have stopped.
• Make sure that the fans are not accessible through air ducts or branch openings.
• If any liquids on electric parts or connections that bear voltage are noticed, stop the operation of the device.
• Do not plug the device into the mains that differ from the one indicated on the label or on the housing.
• Voltage of the mains should comply with the electrotechnical parameters indicated on the label.
• The device should be earthed in accordance with the regulations on the installation of electric devices. Turning on and using an un-
earthed device is not allowed. Follow the requirements specified on the device's labels that indicate danger.
Warnings
• Connection of electricity and maintenance of the device should be performed by qualified personnel only and in accordance with the
manufacturer's instructions and safety requirements.
• In order to reduce the risk during installation and maintenance, suitable protective clothing must be worn.
• Beware of sharp angles while carrying out installation and maintenance works.
• Do not touch heating elements until they haven't cooled down.
• Some devices are heavy, you should be very careful while transporting and installing them. Use suitable lifting equipment.
• When connecting electricity to the mains, a circuit breaker of suitable size must be used.
Warning!
• If the device is installed in a cold environment, make sure that all connections and tubes are properly isolated. Intake and discharge air
ducts should be isolated in all cases.
• Openings of the ducts should be covered during transportation and installation.
• Make sure not to damage the heater when connecting the piping of the water heater. For tightening up, use a wrench/spanner.
Before starting up the device
• Make sure, that there are no strange objects inside the device;
• Manually check fans to make sure they are not stuck or blocked;
• If rotary heat exchanger is installed in the device, make sure that it is not stuck or blocked;
• Check the earthling;
• Make sure that all components and accessories are connected in accordance with the wiring diagram or provided instructions.
4 | EN RIS 700 H EKO 3.0 v2023.1