Installation; Reception Of Goods; Transportation And Storage; Unpacking - Salda RIS 700 H EKO 3.0 Mounting And Installation Instruction
Source: salda.lt/en, vetter-lufttechnik.de
Hide thumbs
Also See for RIS 700 H EKO 3.0:
Table of Contents
Advertisement
5. INSTALLATION
5.1.
RECEPTION OF GOODS
Each device is carefully checked before transportation. When receiving the goods, checking the devices for any damage made during transporta-
tion is recommended. If any damage to the unit is observed, immediately contact the representatives of a transport company. Please inform the
representative of the manufacturer, if any deviation of the device is noticed.
5.2.
TRANSPORTATION AND STORAGE
• All units are factory-packaged to withstand normal conditions of transportation.
• When unpacking, check the unit for any damage made during transportation. Installing
• The packaging is used for protection
• When unloading and storing the units, use suitable lifting equipment to avoid damage and injuries. Do not lift units by holding on power supply
cables, connection boxes, air extract or exhaust flanges. Avoid hits and shock overloads. Before installation, the units must be stored in a dry
room
with relative
air humidity not exceeding 70 % (at +20 °C) and with an average ambient temperature ranging between +5 °C and +30 °C.
The storage place must be protected against dirt and water.
• The units must be transported to the storage place or installation site using forklifts.
• The recommended storage period should not be longer than one year. In case of storing the units for a period longer than one year, checking
if the fan bearings and motor rotate without difficulty (turning the impeller by hand) and if the electric circuit insulation is not damaged or the
moisture has not accumulated must be performed before the installation of the unit.
RIS EKO 3.0
700 HE
700 HW
To prevent damage to the casing, only a product placed on a pallet should be lifted.
5.3.
UNPACKING
Accessories may be packed together with the product. Prior to transporting the unit, the accessories should be unpacked
first.
• Remove the film from the unit.
• Remove the bracing packaging tape that keeps the protective profiles in place.
• Remove the protective profiles.
• After unpacking the unit, examine it to make sure that no damage was made during transportation.
• Before commencing the installation of the unit, please check if all ordered equipment
ment list must be reported to the product supplier.
8
| EN
purposes
only!
H
[mm]
1120
1120
Figure 5.2.1 Lifting by forklift.
the
damaged units is not allowed!
W
L
[mm]
[mm]
840
1370
840
1370
Installation
has
been delivered. Any
Max. number of trans-
ported packages
[pcs.]
1
1
of damaged units is not allowed!
deviation
from the ordered equip-
RIS 700 H EKO 3.0 v2023.1
Advertisement
Table of Contents
