Piping And Instrumentation Diagram; Mounting - Salda RIS 700 H EKO 3.0 Mounting And Installation Instructions Manual

5.4.

PIPING AND INSTRUMENTATION DIAGRAM

* KE1 - only in electrical version; * KV1 - used in water version; ** Possible to control.
THE LIST OF COMPONENTS
C Plate heat exchanger
IF
IV Exhaust fan
TJ Supply air temperature sensor
CO CO sensor
2 2
KE1 Electric heater
M2 Outdoor air damper actuator
TL Outdoor air temperature sensor
NET
TV1 Water heater temperature sensor
KV1 Water heater*
M4 Water heater circulation pump
RC2 Stouch, Flex or ST-SA-Control remote control panel
* Component/posibility to connect it depends on model.
POSIBLE PCB INPUTS/OUTPUTS
FA Fire alarm
H1 Working indication output
5.5.

MOUNTING

•
• When connecting air ducts, consider the labels on the casing of the unit.
• Before connecting to the air duct system, the connection openings of ventilation unit should be closed.
•
RIS 700 H EKO 3.0 v2020.1
PV Supply air fan
PF
TE Exhaust air temperature sensor
DTJ Extract air temperature and humidity sensor
PC Computer
M1 By-pass damper
M3 Exhaust air damper actuator
Ventilated premises
MB-Gateway
DX DX cooler
T1 Water heater thermostat*
M5 Water cooler valve motor
M6 Water heater valve motor*
H2 Alarm indication output
EN | 9