Deletion Of Inactive Stations; Ukw Radio; Manual Search; Automatic Search - TechniSat Transita 121 IR Operating Instructions Manual

> Confirm by pressing the OK/SNOOZE knob.

9.8 Deletion of inactive stations

Channels that cannot be received are marked in the channel list with a "?". You can specifically
delete these channels.
> Press the MENU button and select [Delete inactive channels].
> Confirm by pressing the OK/SNOOZE knob.
> Select [Yes] and confirm by pressing the OK/SNOOZE knob.

10 UKW Radio

Please also refer to the section Setting up the telescopic antenna in this operating manual.
> To select the FM mode, press the MODE button until [FM Radio] appears in the display.
10.1 Set frequency manually
> To change the receive frequency, turn the OK/SNOOZE knob until the desired
transmit frequency appears in the display.
This sets a specific frequency by turning the dial to receive the desired station. If the frequency
is set correctly, the selected station will be shown with its name on the display if it is
broadcasting RDS information.
If you turn the OK/SNOOZE knob clockwise, the frequency will be increased in
0.05 MHz steps. If you turn the SCROLL/SELECT knob to the left, the frequency will
be decreased in 0.05 MHz steps.
10.2 Automatic channel search
As an alternative to manual setting of the reception frequency, automatic station search is also
available. The settings specified in the Search settings apply here.
> Briefly press the OK/SNOOZE knob to start the search. This ends when a strong
enough station is found that can be received.
Seite 19