Table of Contents
Advertisement
8.6 First configuration
When the Transit 121 IR is commissioned and switched on for the first time, a pre-configuration
wizard is launched.
>
First select the language of the display, and when [Do now] appears on the
display, > YES.
If you select NO, the wizard will end and you will need to manually enter the
necessary settings.
You will now be guided step by step through the settings.
>
Under Time format, select the desired time display format.
>
In the next step, you must select the source through which you want to synchronise the
time.
>
Then select the current time zone and whether it is currently daylight saving time or
winter time (only if you have chosen to update via the Internet).
After setting the time and date, some network settings will be made.
>
Make sure your device is within range of the desired Wi-Fi network and you have
access data. In some cases, you may need to make certain settings on your router. If
this is the case, please refer to the relevant user manual.
After searching all available wireless networks, the result will be displayed.
>
Select the desired wireless network and confirm the selection by pressing OK/
SNOOZE .
If it is a protected network, you will be asked to enter the appropriate access key
when you select Skip WPS.
>
To do this, select the appropriate character on the displayed keyboard by turning the
OK/SNOOZE knob.
>
Then enter the selected character by pressing the OK/SNOOZE knob.
If you check and confirm the box
sign. The field
>
Continue in this way until the entire access key is visible in the input field.
>
To confirm password entry, select the
>
To end the wizard when the Setup Wizard Complete message appears on the
display, press the OK/SNOOZE knob .
The initial configuration can be restarted at any time from the menu. For more
information, please refer to section 15.8.
Seite 16
, you can delete the last entered
is used to cancel an entry.
field .
Advertisement
Table of Contents
