Highlight; Language; Factory Settings; Sw-Version - TechniSat Transita 121 IR Operating Instructions Manual

15.3 Highlight

Under [System Settings] > [Lighting], you can adjust the brightness of the display for
operation and standby mode. You can choose between high, medium and low or switch off
in standby mode. The auto dimming function dims the display after
set time in standby mode. Confirm your selection by pressing the OK/SNOOZE knob.

15.4 Language

The system language can be changed under [System settings] > [Language]. Confirm your
selection by pressing the OK/SNOOZE knob.
15.5 Settings factory settings
The system language can be changed under [System settings] > [Language]. Confirm your
selection by pressing the OK/SNOOZE knob.
15.6 Software version
The currently installed software version is displayed under [System Settings] > [Information].
15.7 Settings Internet
In this menu, you will find some settings and information about your internet connection.
> Select [System Settings] > [Internet Settings] to connect to a Wi-Fi network.
> Select [Network Wizard] to establish a Wi-Fi connection.
The network wizard shows all Wi-Fi stations within range.
Select a known Wi-Fi network and choose Skip WPS.
Then enter the appropriate password using the keyboard displayed. Then select
If the password was correct, the connection to this network will now be established. You
can check if there is a connection thanks to the signal bars on the display status bar.
To cancel an entry, select .
If you make a mistake, you can delete the last letter entered
15.7.1 WPS connection
> Select the PBC WiFi configuration if your router has the WPS 2.0 function.
This establishes a direct connection to the router without having to enter
the WiFi password.
To find out how to activate the WPS function on your router, refer to its user
manual.
> Activate the WPS function on the router by pressing the corresponding button.
> After calling up the PBC WLAN configuration function, press the OK/ SNOOZE rotary
button again to establish the WPS connection. Pay attention to the information on
the display.
The WPS function can also be used in the network assistant. To do this, select Press
or PIN after selecting the WLAN. Otherwise, you can use
Seite 26
.
.