Advertisement
SEAT & HANDLEBAR ADJUSTMENT
UP/DOWN
To adjust the seat height, hold onto the seat and pull the seat post up to your desired height.
To lower it you will need to pull the release lever underneath the seat up and while holding the lever,
push the seat down, then release the lever to lock into position.
CAUTION: We recommend to not sit on the seat when pulling up the release lever up as the added
weight can jam the release lever
FORWARD/BACKWARD
The Adjusting lever under the seat acts like a wrench.
To loosen:
Loosen the adjusting handle under the seat by turning it fully to the left side then pull the lever down
and move it back to the right side. Let go of the lever so it slots back into the bolt and then turn to the
left again. Continue doing this until the bolt is loosen enough for you to move your seat.
To tighten:
Once you have set the position you want, tighten by pulling the lever down and move it to the left side.
Release the lever until it clicks to the bolt and then turn the lever to the right.
Repeat by going back to the left side until the seat is fully locked into place.
HANDLEBAR ADJUSTMENT
To adjust the handlebar height, slacken the spring knob and pull it back. Slide the handlebar post along
the housing on the main frame to the desired height and, with the holes aligned correctly, tighten the
spring adjusting knob.
EMERGENCY STOP
On the machine frame there is an emergency knob. Push down on the knob to stop the pedaling motion.
ASSEMBLY INSTRUCTIONS |
13
Advertisement
