Introduction; Symbols And Conventions; Technical Specifications - Labnet Enduro MiniMix Instruction Manual

1.0 Introduction

The Labnet Enduro™ MiniMix is a three dimensional nutating mixer typically used for maintaining the uniform suspension of liquids
over transfer membranes with a minimum volume. The Enduro MiniMix is also ideal for processing Western Blots and staining and
destaining PAGE gels.
The Enduro MiniMix achieves its 3-dimensional mixing by combining the rotating motion of an orbital shaker with the rocking motion
of a platform rocker. The modern styling of the Enduro MiniMix's housing is achieved through the use of injection molded FRABS
plastic. The small platform is constructed of powder coated aluminum topped with a rubber TPE mat.

2.0 Symbols and Conventions

The electrical warning indicates the presence of a potential hazard which could result in electrical shock.
CAUTION: This symbol refers you to important operating and maintenance (servicing) instructions within this Instruction
Manual. Failure to heed this information may present a risk of damage or injury to persons or equipment.
This symbol identifies a Protective Earth (PE) terminal, which is provided for connection of the supply system's protective
earth (green or green/yellow) conductor.
3 .0 Technical Specifications
Motion
Speed
S0600
S0600-230V
Platform Tilt Angle
Dimensions (W x D x H)
Platform Dimensions
Weight
Platform Load Capacity
Platform Capacity without Stacking
Electrical
S0600
S0600-230V
Temperature Range
Protection Class
The Labnet Enduro MiniMix is designed to be safe at least when operated under the following conditions:
Indoor use only

Altitude up to 2,000 meters

Pollution degree 2

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. The equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the user manual, may cause harmful interference to radio communications. Operation of equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference.
CAUTION: This equipment is not intended for use in residential environments and may not provide adequate protection
to radio reception in such environments.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
3-dimensional rocking rotating
18 rpm
20 rpm
5°, fixed
9.5 x 5.75 x 6.75 in. (24 x 14.6 x 17 cm)
9.5 x 6.75 in. (20 x 16.5 cm)
1.88 lbs. (0.85 kg)
1.75 lbs. (0.8 kg), balanced
Four 8 x 10 cm (Bio-Rad, NuSep) or two 10 x 10 cm (Lonza, Invitrogen) blotting boxes
120V~, 50/60 Hz, 0.03A, 3.6W
230V~, 50/60 Hz, 0.017A, 4W
5°C to 40°C (up to 80% RH at 31°C, decreasing linearly to 50% RH at 40°C)
IP21
Instruction Manual | 1