Introduction; Symbols And Conventions; Safety Information - Labnet Spectrafuge 16M Instruction Manual

1.0 Introduction

The Labnet Spectrafuge™ 16M Microcentrifuge is a small benchtop centrifuge designed for separation of various research samples.
The motor is brushless and requires no routine maintenance. The Spectrafuge 16M is supplied with an 18 x 1.5 mL rotor for micro-
samples. Adapters are available for tubes smaller than 1.5 mL. The Spectrafuge 16M reaches speeds of up to 14,000 rpm/16,000 x g.

2.0 Symbols and Conventions

The electrical warning indicates the presence of a potential hazard which could result in electrical shock.
CAUTION: This symbol refers you to important operating and maintenance (servicing) instructions within this Instruction
Manual. Failure to heed this information may present a risk of damage or injury to persons or equipment.
This symbol identifies a Protective Earth (PE) terminal, which is provided for connection of the supply system's protective
earth (green or green/yellow) conductor.

3.0 Safety Information

NOTE: All users of the centrifuge must read the Safety Information section of this manual before attempting to operate the unit.
If this equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be
impaired.
Never use the centrifuge in any manner not specified in these instructions.

Never operate the centrifuge without a rotor properly attached to the shaft.

Never fill tubes while they are in the rotor. Liquid spillage may harm unit.

Never put hands in the rotor area unless the rotor is completely stopped.

Never move the centrifuge while the rotor is spinning.

Never use solvents or flammables near this or other electrical equipment.

Never centrifuge flammable, explosive, or corrosive materials.

Never centrifuge hazardous materials outside of a hood or proper containment facility.

Always load the rotor symmetrically. Each tube should be counterbalanced by another tube of the same type and weight.

Always locate the centrifuge within easy access to an electrical outlet.

Always use only microcentrifuge tubes made from plastic and designed to withstand centrifugal forces of at least 16,000 x g.

Do not operate the centrifuge if any of the following conditions exist:
The centrifuge has not been installed properly.

The centrifuge is partially dismantled.

Service has been attempted by an unauthorized or unqualified personnel.

The rotor has not been installed securely on the motor shaft.

Rotors and accessories not belonging to the standard range are being used without permission being obtained from the

manufacturer to use such rotors and/or accessories in the centrifuge. Exception: Microcentrifuge tubes made of plastic, normally
available in the laboratory.
The centrifuge is located in an explosive atmosphere.

Materials to be centrifuged are combustible and/or explosive.

Materials to be centrifuged are chemically reactive.

The rotor load is not properly balanced.

Instruction Manual | 1