Advertisement
Please contact Advantech customer service for further support.
2.6.4
There is no battery power
Please check:
1.
Make sure the battery pack is installed properly. Please push the pack inside the
battery slot.
2.
Check that the DC-in connection is plugged in properly.
3.
If a battery is used, the battery capacity should be under 98% to initialize the
charge.
This design avoids frequent charging.
In other words, if the battery capacity is 99% or 100%, the charger will not
charge the battery.
Contact your distributor, sales representative, or Advantech's customer service cen-
ter for technical support if you need additional assistance. Please have the following
information ready before you call:
Product name and serial number
Description of your peripheral attachments
Description of your software (operating system, version, application software,
etc.)
A complete description of the problem
The exact wording of any error messages
Symptoms, photo, or video if available
2.7
EMC Declaration
Guidance and Manufacturer's Declaration – Electromagnetic Emissions
The POC-624-02 series device is intended for use in an electromagnetic environment as
specified below. The customer or the user of the POC-624-02 series device should ensure
that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Electromagnetic environment –
Compliance
guidance
The POC-624-02 series device
uses RF energy only for its inter-
nal functions. Therefore, its RF
Group 1
emissions are very low and are
not likely to cause any interfer-
ence in nearby electronic equip-
ment.
The POC-624-02 series device is
Class B
suitable for use in all establish-
ments, including domestic estab-
Class D
lishments and those directly
connected to the public low-volt-
age power supply network that
Meets the require-
supplies buildings used for
ments
domestic purposes.
15
POC-624-02 Series User Manual
Advertisement
