Table of Contents
Advertisement
7.3. - Refund slide.
This is the system that makes it possible to extract coins from the bottom of each
change tube by a claw. It also has two safety locks to avoid the accidental falling of
the coin in the tubes.
7.4. - Technical characteristics.
Size:
Weight:
Steady supply current:
Peak supply current:
Power supply:
7.5. - Power and communication cable.
The connections between the X-10 compact and the machine is made through a
MOLEX 39-01-2080 connector.
The connections are :
N1 Colour
1
White
Brown
2
Green
3
Red
4
5
Yellow
Grey
6
Pink
7
------
8
7.6. - Installation of the coin mechanism.
Verify that the compact is installed vertically and that the refund lever of the validator
is not activated.
Connect the compact. Verify that the coins programmed on address 50 correspond
with the size of the tubes. If the communication is running correctly you can see the
status led of the compact flashing.
Introduce at least three coins in each tube through address 02, as indicated in the
first reload.
Introduce a coin and carry out a purchase (repeat this process with different coins and
channels of the machine).
Unload coins from the tubes (address 03) and verify that they fall correctly into the
refund drawer.
7.7. - Cleaning of the validator.
Periodical cleaning of the walls and ramps of the validator, where the coins circulate,
with a rag or damp cloth impregnated with alcohol is recommended.
MNP45GBV02
353 x 137 x 82 mm
2,8 kg.
≈
150 mA.
4 A.
12 VDC
Function
Power GND
Logic GND
Logic VCC
Control 485
Power VCC
AS (C. 485)
BS (C. 485)
N.C.
27/03/04 Rev. 1
FRONT VIEW
5
6
7
1
2
3
8
4
Page 28 of 40
Advertisement
Table of Contents
