Table of Contents
Advertisement
VERY IMPORTANT:
For the machine to work correctly, the first reloading of coins must take place
through direction of programming 2 of the machine (this reloading must consist
of at least three coins per tube) as is indicated on page 12 of the present
manual.
At this point the machine is ready to accept coins or enter into programming mode
(prices, reloading of coins, etc.).
4. - Selling Mode.
When the machine is switched on after the initial check, the time is shown on the
display, the machine awaits the introduction of coins.
introduced, the credit appears on the display. Credit will only be accepted if the
machine is able to return it, until the maximum price has been reached and if the
machine have products.
automatically returned. This credit is maintained indefinitely on the display until a
request is made, or until the refund button is pressed. If a sale is to be made and the
machine can provide sufficient change, the vend is done. On the contrary the vend
will not be made. For the different sale modes see the programming mode 15 SALE
OPTION and 17 ESCROW UNIT.
5. - Programming Mode.
In order to enter or exit the programming mode and also to get to the different
programming options, one must press the programming button situated on the
interior, upper part of the door (see figure 1.01). If no channel is pressed, or no coin is
introduced (in the case of tube reloading) for a period of 2 minutes, the machine will
automatically leave the programming mode and return to standby, indicated by the
clock.
In order to modify the content of the programming options, the machine's selection
channels and refund channel must be used.
These channels should be used in the order and in the manner described below, for
each option.
MNP45GBV02
Place each product label on the relevant channel by
introducing it through slot 1. The price label is placed in gap
2, as is indicated in the figure. The thickness of the labels
should never be more than 0,3 mm.
In order to start the machine, all you have to do is connect it
to the supply and turn on the main switch (see figure 1.01).
The machine starts up by making an internal auto test. When
this is over, the time appears on the display.
If more than 20 coins are introduced, the credit is
27/03/04 Rev. 1
When the first coin is
Page 13 of 40
Advertisement
Table of Contents
