7. - Introduction to model X-10.
The X-10 validation group is an integrated system made up of an electronic coin
validator and a refund system for automatic vending machines with RS-485 protocol.
It consists of a electronic coin validator model T11, a 5 routes coin separator and five
self loading change tubes.
Its water protection system allows it to run in a hard environment.
7.1. - T11 Validator.
The T11 is an electronic validator that can identify up to 24 coins or tokens. It has a
built in separating system with a coil that rejects or accepts the coins. It is powered by
12VDC through a connector to the control board.
7.2. - Coin separator.
This subsystem permits the routing of accepted coins by the T11 validator to reload
the five change tubes or the coin deposit. It has photo-sensors in the bottom to make
the coin acceptance faster and detect coin jams in the top of change tubes.
MNP45GBV02
27/03/04 Rev. 1
Page 27 of 40