Jofemar argos Series Instruction Manual page 17

OP_7 CLEARING MACHINE FAULTS.
By pressing refund, all the faults detected at option 06 are placed at zero, the display
will flash for a few seconds.
OP_8 MANUAL OPERATION OF THE MACHINE AND CONFIGURATION OF
MACHINE TYPE.
In order to position the extractors, you press button 1. The message "button 2 to
move motor 01" appears on the display. If the extractor you wish to move is not
number 1, you keep pressing button 1 until the motor you wish to move appears on
the screen, button 2 should then be pressed to move this extractor.
The special extractors appear pressing channels 42 to 47 both included.
Configuration of Machine type:
By pressing refund and button 1 twice, the message "PRESS BUTTON TO
CONFIGURE THE MACHINE" appears on the display.
The following buttons configure the machine type;
- button 7 for ARGOS 7.
- button 11 for ARGOS 11.
- button 15 for ARGOS 15.
- button 21 for ARGOS 21.
When one of the above buttons is pressed, the message "CONFIGURED GOYA XX"
appears on the display.
As well as configuring the machine type, the following operations take place:
- Reset of RAM, all counts are put at zero.
- Prices-check, if any price is programmed at 0000 or at any price is not
divisible by the base coin, the price is programmed at 300.
- Checking of channels linking, if the link is incorrect, a correct link for the
channels is programmed and the currency (OP _35) is set to "PTS".
- Programming of the standard massage, to "PRECIO PULSANDO TECLA.
GRACIAS POR SU VISITA".
If, instead of pressing one of the channels mentioned above, you press:
- Button 5, all the extractors that are found without products will be correctly
positioned and the message "POSITIONING EXTRACTORS" will appear on
the display.
- Button 6, all extractors will be checked and all of them will be programmed
for the standard link (OP _ 9).
OP_9 LINK CHANNELS.
When refund is pressed the following message will appear on the screen; "PRESS A
CHANNEL TO MAKE LINK".
In order to link several buttons, they must have been programmed with the same
price at option 00.
When the above message can be seen on the display, you press the buttons to be
linked and activate the product micro of the extractor or extractors to be linked (if
there is a product there, lift it up, and if not, press it down for a moment). Then press
refund.
Perform this operation for each group to be dealt.
MNP45GBV02 27/03/04 Rev. 1 Page 17 of 40