Fig. 11 Dimensions Push Button Extension; Fig. 12 Delivery State Clamping Lever - Beckhoff CP6706-0001 Manual

200
Fig. 11: Dimensions push button extension
Preparation of the control cabinet
The control cabinet must have the required installation cutout according to the device dimensions of the
panel PC.
The wall thickness must be between 1 mm and 5 mm for installation. After installation, be sure to check the
tightness between the panel PC and the wall.
Please also note the following for installation in a control cabinet:
• Ensure that there is 5 cm of free space above and below the device for air circulation.
• Position the panel PC such that reflections from light sources on the screen are avoided as far as
possible.
• For the correct installation height, use the position of the screen for guidance. This should always be
optimally visible to the user.
• Do not expose the panel PC to direct sunlight.
Installation in the control cabinet
Once you have made the required cutout in the control cabinet, you can install the panel PC in the control
cabinet. Clamping levers are provided at the rear side of the housing for mounting of the device. In the
delivery state, the clamping levers are turned onto the device (see Fig. 12).
Fig. 12: Delivery state clamping lever
To install and secure the control panel in the control cabinet, follow the steps shown in Fig. 13 and 14:
1. Insert the control panel at the intended position in the control cabinet wall. Make sure that the device is
secured against falling out until it is fastened properly.
CP6706-0001
76
7
6
31
200
Version: 2.0
Commissioning
191
21