Baxi MK SYSTEM Installation, User And Service Manual page 42

9 Parameters
Tab.29 > Settings
Parameters Description of the parameters
BL input setting Blocking input setting (1: Full blocking, 2: Partial blocking, 3: User reset locking)
AP001
Full blocking
Partial blocking
User reset locking
Backup relieved
Generator relieved
Gen.&Backup relieved
High, Low Tariff
Photovoltaic HP Only
PV HP And backup
Smart Grid ready
Heating Cooling
Manual Heat Activating the manual heating demand
Demand
Off
AP002
With setpoint: In this mode, the temperature setpoint used will be that for the
Setpoint manual HD (AP026) parameter.
Service hours Number of heat generator operating hours before raising a service notification
AP009 Can be set from 0 Hours to 65534 Hours
Service notification Select the type of service notification
AP010
None
Custom notification
Service hours mains Hours powered to raise a service notification
AP011 Can be set from 0 Hours to 65534 Hours
Forced cooling The cooling mode is always enabled and no longer controlled by the outdoor
mode temperature
AP015
No
Yes
CH function on Enable central heating demand processing
AP016
Off
On
DHW function on Enable domestic hot water heat demand processing
AP017
Off
On
Setpoint manual HD Flow temperature setpoint for manual heat demand
AP026 Can be set from 7 °C to 70 °C
Setpoint used when manual mode is active (Manual Heat Demand (AP002) =
With setpoint)
Cooling mode Configuration of the cooling mode
AP028
Off
On
Cooling permission Grant permission for the heat pump to be able to deliver cooling
AP029
Not allowed
Allowed
Max CH flow Maximum central heating flow temperature setpoint
setpoint Can be set from 20 °C to 90 °C
AP063
Humidity sensor Humidity sensor configuration
AP072
No
OnOff
0-10V
BL1 contact config BL1 input contact configuration
AP098
Open
Closed
42
Factory setting
EHC-14
Partial blocking
Off
4000 Hours
None
8700 Hours
No
On
On
40 °C
Off
Allowed
Backup boiler: 80 °C
Heating element: 75
°C
No
Open
7856310 - v02 - 21122023