Installing Batteries; Ups Cable Connection Reference - Huawei UPS5000-E-125 kVA User Manual

UPS5000-E-125 kVA
User Manual (Integrated UPS 3.0, 02291136)
Step 9 Install the cabinet rear door on the enclosure frame that has been installed.
After installing the cabinet rear door, ensure that ground cables are properly
connected to the cabinet and rear door.
----End

3.2.3 Installing Batteries

Installing Lead-Acid Batteries
● Before installing batteries, read through the battery safety precautions, obtain
● Install the batteries from the lower layer to the upper layer to prevent falling

3.2.4 UPS Cable Connection Reference

Context
● When preparing cables, keep away from the cabinet to prevent cable scraps
● After installing cables, clean the cabinet top, bottom, copper bar wiring
● Prepare terminals onsite. The length of the copper wire should be the same as
Procedure
Step 1 Route a cable into the cabinet and bind it to a nearby beam.
Step 2 Pull the cable to the copper bar to which the cable is to be connected, determine
the cable length, and mark the cable at the position where the cable is to be cut.
Step 3 Pull the marked cable out of the cabinet, cut the cable from the marked position,
strip the cable, and crimp a terminal.
Issue 01 (2022-09-26)
NO TICE
D ANGER
the delivered battery installation guide, and install batteries as instructed.
over due to imbalance.
WARNING
from entering the cabinet. Cable scraps may cause sparks during power-on and
cause personal injury or device damage.
positions, and other positions. Ensure that there is no dust or scraps inside and
around the cabinet.
that of the part of the terminal that covers the conductor.
Copyright © Huawei Digital Power Technologies Co., Ltd.
3 Installation
68