Disabling And Enabling Protocols: Phaser 750 Front Panel; Disabling Protocols: Phasershare Administrator - Tektronix Phaser 750DP Install Manual

Disabling and enabling protocols: Phaser 750 front
panel
1.
When the front panel displays
2.
Press the right-arrow (---->) button until Configuration is displayed. Press the Menu
button.
3. Press the right-arrow (---->) button until Network Settings is displayed. Press the
Menu button.
4.
Press the right-arrow (---->) button until the desired protocol is displayed (for
DHCP/BOOTP, display TCP/IP at this point). Press the Menu button.
For HTTP, EtherTalk, TokenTalk, and IPP
a.
Press the right-arrow (---->) button until On or Off is displayed.
b.
Press the Menu button.
For TCP/IP and NetWare
a.
Press the right-arrow (---->) button until Interface is displayed. NOTE: For
DHCP/BOOTP, display DHCP/BOOTP rather than Interface. Press the Menu
button.
b.
Press the right-arrow (---->) button until On or Off is displayed, depending on
whether you want to enable or disable the protocol. Press the OK button.
5. To return the printer to normal operation, press the Exit button (the left-most button)
until the front panel displays Ready.

Disabling protocols: PhaserShare Administrator

1.
In the PhaserShare Administrator Main window, select the desired printer from the
Printer List.
2.
Click Configure Printer.
3.
In the Configure Printer dialog box, click the Ethernet (or Token Ring) tab.
4.
In the Ethernet (or Token Ring) tab, click Protocol Settings.
5.
In the Protocol Settings dialog box, click the tab for the protocol you want to disable.
6.
On the tab for the selected protocol, find the field for enabling or disabling the
protocol. Select No.
7.
Click OK.
For more information on the PhaserShare Administrator, see Novell NetWare on page 7.
Networking Setup Guide
Disabling and Enabling Protocols
press the Menu button.
Ready,
43