Disabling And Enabling Protocols; Determining Which Protocols Are Enabled - Tektronix Phaser 750DP Install Manual

Phasershare networking

Hide thumbs Also See for Phaser 750DP:

Table of Contents

Disabling and Enabling Protocols

After your network configuration is complete, you may want to disable protocols that you

are not using to avoid unnecessary network traffic. There are four ways to disable

protocols:

Use the printer's front panel; see Disabling and enabling protocols: Phaser 750 front

panel on page 43.

In NetWare environments, you can use the PhaserShare Administrator; see Disabling

protocols: PhaserShare Administrator on page 43.

With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink

Printer Management Software; see Disabling protocols: PhaserLink Printer

Management Software on page 44.

Send the appropriate PostScript utility file to the printer. See the README files on

the printer's CD-ROM. The PC README file is in the UTILS directory; the Macintosh

README file is in the Network Utilities folder.

You can enable protocols by the same procedures; just select the command to enable a

protocol rather than disable it.

All protocols can be enabled and disabled. The Configuration Page reports which

protocols are enabled. If a protocol is enabled, the field for that protocol lists the current

parameters. If the protocol is disabled, the field for that protocol contains an entry reading

Disabled.

Phaser 750 Color Printer

Table of Contents