Cisco Room Kit EQX Installation Manual page 64

23.2. Move the screen bracket stoppers
1. Push the screen gently, to pop out the screen.
2. Locate the screen bracket stoppers that are fastened on top of the rails. Only the ones
closest to the system center are used.
Screen bracket stoppers
3. Loosen the screw and slide the stopper as shown in the illustration.
(Hex 4 mm)
That is, the distance between the stopper and the closest interface arm should be
(where B is the distance that you measured in step 23.1).
B-1 mm
4. Tighten the screw to fasten the stopper in its new position.
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
B-1 mm
Screen bracket
stopper for the
C
left screen
5. Lift the left screen off the VESA rail. Place it safely on the floor until you mount it permanently
in step 24.
6. Measure the distance C to the left screen bracket stopper, and move the stopper for
the right screen to match this distance. Tighten the screw when the stopper is in its new
position.
64
C
Screen bracket
stopper for the
right screen
Copyright © 2024 Cisco Systems, Inc. All rights reserved.