Cisco Room Kit EQX Installation Manual page 63

23.1. Temporarily hang the screen on the VESA rail
1. Push both interface arms firmly, to put them in pop-out mode.
mind your fingers!
2. Hang the screen onto the rail 50-70 mm (2-3 in.) to the side
sure the interface arms hooks into the groove as shown in the close-up.
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
They pop out quickly, so
of the system center line. Make
The interface arms
hooks into the groove
on top of the rail.
3. Push the screen gently, so that the screen stays popped in.
If it doesn't lock in pop-in mode, use the lower depth adjustment wheels (see step 26.2) to
make more space between the screen and mounting structure. Then, try again.
4. Measure the distance B accurately; you need it in step 23.2.
5. Measure the distance A; and take note whether the screen is higher or lower than the
T-mark. You need this information in step 23.3.
63
A
B
The T-mark on the grille shows:
• The system center line
• The top of the screens
System center line
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
Top of
screens when
mounting is
finished