Table of Contents
Advertisement
The main cable routing areas
Behind the flap - from the channels
and through the holes for the camera
and loudspeakers.
Keep the cables
away from the loudspeakers to avoid
rattling noise. Use the supplied velcro
straps.
The bottom trays.
Keep the cables
away from the bass to avoid rattling
noise. Use the supplied velcro straps.
The channels between the modules.
Also the channels on the sides can be
used, if convenient for the socket outlet
location in your room.
Thread cables through the holes where
convenient.
In the stand. You can route cables in
the stand. The stand covers will hide
them.
You can lead cables out from the stand
only at center. You can lead them
toward front (the table), back, or down.
In front of the codec and amplifier
clamps. All cables for the codec/
amplifier comes from the channels
between the modules.
Lead the cables out through one of the
holes, across the clamp, and then back
again to the connector panels. This is
important for strain relief.
When done, fasten the cables with
velcro.
A few cables also run across from left
to right just below the clamps.
Keep
the cables away from the bass to avoid
rattling noise. Use the supplied velcro
straps.
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
25
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
Advertisement
Table of Contents
