Mount The Loudspeakers - Cisco Room Kit EQX Installation Manual

8. Mount the loudspeakers

There are three loudspeakers on each side - and a bass unit.
Their cables are bundled, and have a common connector
connected to the amplifier. The other ends of the cable
bundle are labeled S1, S2, S3, S4, S5, S6, SB1 to identify
which cable goes to which loudspeaker.
Loudspeakers
12x
6x loudspeaker (Box: Speakers)
1x bass (Box: Bass) 6x
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
8.1. Connect and arrange the cables
1. Connect the loudspeaker cable to the amplifier.
2. Route the other ends of the cable bundle as shown in the
illustration. Let the ends hang freely at this point.
Check the labels, because it is important for the audio
experience that the correct cable is connected to the
correct loudspeaker.
To left
loudspeakers
A1
To right
loudspeakers
(M4x10, Torx T20)
and bass
(Box: Center kit)
(M4x8, Torx T20)
(Box: Center kit)
S1
S2
S3
30
S4
S5
SB1
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
S6