Dip Switch - Panasonic VL-W1 Series Setup And Maintenance Manual

1-6-3 DIP switch

Set the operational options of the laser processing
machine with the DIP switch equipped on the controller
rear side.
• A plastic cover is installed on the DIP switch. Install
this cover always to avoid the dust penetration to the
controller.
• The initial setting of all DIP switches is OFF.
• Turn OFF the power at DIP switch setting.
Item
No. 1
No. 2
No. 3
No. 4
No. 5
38
Description
System reservation. Keep OFF state.
Select the control method, I/O or command for some specific operations.
ON Control by serial communication commands for the following operations
• Laser pumping (LSR)
• Shutter open/close (SHT)
• Guide laser (GID)
• Laser radiation for measurement (SPT)
OFF Control by I/O for the following operations
• Laser power supply (Laser pumping)
• Shutter open/close
• Guide laser radiation
Select the ON/OFF of the buzzer sound to notify the alarm or warning occurrence.
ON Disables the buzzer sound for alarm or warning state.
OFF Enables the buzzer sound for alarm or warning state.
Select the ON/OFF of the password lock to change the screen mode from "Run" to
"Setting". Refer to "When password is forgotten" (P.72).
ON Disables the password lock.
OFF Enables the password lock.
Select the setting method of the remote mode.
ON Use the input signal of X5 "REMOTE IN" on I/O terminal.
OFF Use the remote switch on the front of the controller.
• When DIP switch No. 6 is ON, keep DIP switch No. 5 OFF.
ME-VLW1-SM-8
ON
OFF
VL-W1500, VL-W1506
Rear of controller
DIP switch
VL-W1A00, VL-W1A06