Power On/Oft The X4 Pro Li-Po Battery; Check The Li-Po Battery Power - Hubsan X4 PRO Manual

BATTERY
(1) Overcharge protection
(2) Over-discharge protection
(3) Short circuit protection
Overcharging will damage the battery, charging will stop
when the battery charge to 12.8V
Over-discharging will damage the battery, the X4 Pro will
cut off power when the battery power is 8.4V
when detect Short circuit protection, the X4 Pro will power
off to protect the battery
1.3 POWER ON/ OFF THE X4 PRO LI-PO BATTERY
Power on: Put the battery into the battery compartment, connect the battery plug with correct
polarity, then the X4 Pro is power on The LED on X4 Pro will circularly blink blue.
Power off: Disconnect the battery plug, the X4 Pro is power off, the LED will turn off_
1.4 CHECK THE LI-PO BATTERY POWER
After the X4 Pro and the Transmitter finish pairing, the battery power will display on the screen.
11.5V I BATTERY POWER
• H+45°
R1
-
7-
M 7.6V I
P-1 , I°
50.
0x
p,am
k
+0.0m
N00.0000000 E000.0000000
M2 0:01:56
Always partially charge your I ipo battery before
storage
LiPo batteries retain a charge over a reasonable period; It is not normally necessary to recharge
stored LiPo batteries unless stored for periods longer than 3-6 months_
If your LiPo battery has been over-discharged, it will not be possible to recharge it again.
•
LiPo Battery Disposal & Recycling
Lithium-Polymer(LiPo) batteries must not be placed in with household trash. Please
contact your environmental or waste agency or the supplier of your model for local
regulations and the location of your nearest LiPo battery recycling center_
07 I
Etna -1
,4,-,' ' ' u.. °;:yrE