Hubsan X4 PRO Manual page 11

11
.3.2015 I- ubsan
rt.M.G113
EXTERNAL INTERFACE
CAMERA
• Need power on the camera, then copy. The camera is only recharging when it is power
off and connect to the PC_ The camera cannot shooting when it connect to PC.
• Remove the camera USB connector from the camera when it is shouting, the camera
will be still shooting. Other conditions, the camera will be automatically power off if USB
connector disconnect the camera.
• The camera will be recharging while connect to the X4 Pro or the PC, charging circuit is
about 500rnAh, the camera battery is 3/V/ 670mAh.
3.2.4 CAMERA INDICATING LIGHT
Use the Micro-USB connect to the PC when the camera is power on, copy the pictures/videos
from the camera and charging the camera at the same time
Camera indicating light Camera condition
Blue light tums on Standby
Blue light tums on, red light blinks once every
second
Recording
Blue light tums on, red light tuns on
Camera module is faulty
Blue light blinks every second Micro-SD card will be full/ no SD card/ faulty SD card
Blue light blinks quickly
Micro-SD card is full
Red light blinks quickly
Battery power is low
I
2.2.5 INSTALL THE CAMERA
Method: t Unscrew the fix set for camera, remove the fix set_
2. Put the camera on the slot(camera facing outside), install the fix set, fix it with screws.
3. Plug the camera data wire into the USB interface, plug the other end into the X4 Pro
external interface (see more details on 2_3_1) .