Power On/ Off The X4 Pro Li-Po Battery; Check The Li-Po Battery Power - Hubsan X4 PRO Manual

(1) Overcharge protection
(2) Over-discharge protection
(3) Short circuit protection

1.3 POWER ON/ OFF THE X4 PRO LI-PO BATTERY

Power on: Put the battery into the battery compartment, connect the battery plug with correct
polarity. When the X4 Pro is power on, the blue LEDs on X4 Pro will blink in a rotating pattern.
Power off: Disconnect the battery connector plug to remove power from the X4 Pro. The LEDs
will turn off.

1.4 CHECK THE LI-PO BATTERY POWER

After the X4 Pro and the Transmitter finish pairing, the battery power will display on the tablet.
Always partially charge your lipo battery before storage.
LiPo batteries retain a charge over a long period at about a 50% or 3.85v per cel storage
charge. It is not normally necessary to recharge stored LiPo batteries unless stored for periods
longer than 3-6 months.
If your LiPo battery has been over-discharged, it will not be possible to recharge it again.
LiPo Battery Disposal & Recycling
Lithium-Polymer(LiPo) batteries must not be placed in with household trash. Please
contact your environmental or waste agency or the supplier of your model for local
regulations and the location of your nearest LiPo battery recycling center.
Overcharging will damage the battery, charging will
stop when the battery charge to 12.8V.
Over-discharging will damage the battery. The X4 Pro
will cut off power when the battery power is 8.4V.
Short circuit detection. The X4 Pro will power off to
protect the battery.
BATTERY POWER
BATTERY
©
2015 Hubsan
07