Hubsan X4 PRO Manual page 21

START TO FLY
When the installation is finished, please do some practices and training (For example: use
some imitator to do some fly training or ask some professional guidance.) Please choose the
suitable place to play the X4 Pro.
THE FLIGHT ENVIRONMENT FOR X4 PRO
(1) Fly the X4 Pro in an open place. The GPS signal may become weaker and the position
holding and RTH function may lapse when the X4 Pro fly around trees and buildings.
(2) Do not play the X4 Pro in the bad weather. Such as, strong wind, heavy snow, rainy day and
foggy day.
(3) When play the X4 Pro, please keep away from the barrier, people, high-line cable, trees and
so on.
(4) Do not play the X4 Pro in places such as station and launch tower, to avoid interaction.
(5) Can not play in the south and north pole.
(6) Do not place the X4 Pro in the forbidden place.
CHECK BEFORE FLYING
(1) Make sure the power is full of the Transmitter, X4 Pro, parachute, and camera.
(2) Make sure the propellers install correctly.
(3) Make sure the gimbal vibration setting is completely and the installation is correctly.
(4) Make sure whether the plug of the parachute is in or out, and make sure the power of the
parachute is full.
(5) Make sure insert the Micro-SD card when do shooting and recording.
(6) Make sure when the power on, the camera and gimbal can work normally.
(7) Make sure whether the motor can work normally or not
5.BIND THE TRANSMITTER AND THE X4 PRO
Power on the transmitter, then the X4 Pro: the transmitter will show the lipo battery voltage and
other values as below shows. If no value shows, need to bind the transmitter to the X4 Pro.
Power on the transmitter, then press the ENTER button until the LCD displays 'System
initialize, power on the X4 Pro when the LCD screen displays "Bind to aircraft", the binding will
be finished in 3 seconds.
GPS
HUBSAN
11.5V
L 7.6V
5
H+49°
R+7°
P+3°
SO. ON
T„
Om
i.
+0.0m
Bind to aircraft
N22/911066 E114.0477988
. M2 0:04:47
21
©2015 Hu0san
181*1011.1 /1t4Ifili