Hubsan X4 PRO Manual page 18

FPV TRANSMITTER
4.2 INPUT KEY FUNCTION
S/N IDENTIFICATION FUNCTION
1 Throttle/Rudder Stick
Forward and backward movement of the stick will make the X4 Pro
increase or decrease speed respectively.Leff and right movement of the
stick makes the X4 Pro yaw left/right respectively.
2 Elevator/Aileron Stick
Forward and backward movement of the stick makes the X4 Pro nose
point up/down respectively. Left and right movement of the stick
makes the X4 Pro roll left/right to initiate a tum.
(1) Throttle /Aileron stick
Forward and backward movement of the stick will make the X4 Pro
increase or decrease speed respectively.Left and right movement
of the stick makes the X4 Pro roll left/right to initiate a tum.
(2) Elevator/Rudder Stick
Forward and backward movement of the stick makes the X4 Pro
nose point up/down respectively. Left and right movement of the
stick makes the X4 Pro yaw left/right respectively_
3 Aileron Trim Aileron tarn adjusts left and right roll.
4 Elevator Trim Elevator trim adjusts up and down movement
5 Rudder Trim Rudder trim adjusts left and right yaw.
6 Throttle Trim Throttle turn adjusts speed of motor.
7 Power SW
Pushing the switch up powers on the transmitter, pulling it down
switches it off.
8 Neck Strap Eyelet
For the attachment of a neck strap which eases the tension of your
hands from holding the transmitter.
9 Antenna Transmits the 2.4Ghz wireless signal.
10 TlISB No function for now
11 SA
Push: Headless Function
Pull down: Normal Function
12 GPS
Push: Altitude mode and Position Mode
Pull down: Exit the Altitude Mode and Position Mode
13 Home
Push: Enter the RTH function.
Pull down: Exit the RTH function_
14 DSC (Optional) Connects to the data cable of computer simulator.
18
&MS
HLOsan
159110-gg MR**