Printer components and options
Roll feeder support (DP155 and DP180 EPS only)
3- 4
Figure 3-5
Printer with inverter feeder/stacker,
one feeder/stacker, and bypass transport
Figure 3-6
Printer with inverter feeder/stacker,
two feeder/stackers, and bypass transport
The roll feeder option may be installed in the inverter feeder/
stacker module, replacing the feeder tray. This option does not
require DFA or input enablement software, or any additional
hardware.
The maximum number of feeder/stacker modules supported for
this configuration is four, including the inverter module with the roll
feeder. With the two processor feeder trays, this makes a total of
six input trays possible.
Installation Planning Guide