Xerox DocuPrint 100 Installation Planning Manual page 96
Xerox docuprint 100: install guide
Hide thumbs
Also See for DocuPrint 100:
- Software manual (498 pages) ,
- Service manual (304 pages) ,
- Installation planning manual (242 pages)
Table of Contents
Advertisement
Supplies
Using large paper
sizes in 3 pitch
mode
A - 6
Figure A-1 8 pitch mode paper sizes
1. Maximum paper size for 8 pitch mode
2. Minimum paper size for 8 pitch mode
3. Travel direction of sheets out of paper tray
Large paper sizes with widths of 15.31 to 17 inches / 389 to 432
mm are supported only in 3 pitch mode and must feed short edge
first. These paper sizes slow down the throughput speed.
Therefore, a short edge feed job takes longer to print than a long
edge feed job.
NOTE: The system can support 14 by 17 inch / 356 by 432 mm,
20 pound or 80 gsm paper stock in 3 pitch mode. However,
printing performance is not guaranteed for all types of paper of this
size. Heavy (110 pound / 200 gsm) and light (16 pound / 60 gsm)
weight papers can cause jams throughout the system, and are not
recommended.
The following figure illustrates the maximum and minimum paper
sizes supported in 3 pitch mode.
Installation Planning Guide
Advertisement
Table of Contents
