Roll Feeder Support; Advanced Paper Handling - Xerox DocuPrint 96 IPS System Overview Manual

Roll feeder support

Advanced paper handling

XEROX DOCUPRINT 96/4635/180 IPS SYSTEM OVERVIEW GUIDE
The 96, 4635, and 180 IPS can each accommodate a third-party roll
feeder as an optional input tray.
•
The 96 and 4635 IPS have an optional configuration in which
the roll feeder interfaces with the last feeder/stacker module.
With this configuration the 4635 IPS may have up to six feeder
trays with the sixth being the roll feeder. The 96 IPS may have
up to five input trays, with the roll feeder as the fifth.
Note: To be able to use this roll feeder option on the 96/4635
IPS, you must have the Input Enablement kit installed. (Refer to
"Options enabling feeding and finishing," later in this
chapter.)
•
The roll feeder option for the 180 IPS is installed in the inverter
feeder/stacker module, replacing the feeder tray. It does not
require the Input Enablement kit or DFA software. The
maximum number of feeder/stacker modules supported for this
configuration is four, including the inverter module with the roll
feeder. With the two processor feeder trays, this makes a total
of six input trays possible.
The 96/4635/180 IPS can handle paper stock ranging in size from 8
by 10 inches / 203 by 254 mm to 14.33 by 17 inches / 364 by 432
mm, including sizes A3 and A4. They process paper weights from 16-
to 110-pound / 60 to 200 gsm.
Note: The 4635 and 180 IPS can also print on paper as small as 7
by 10 inches / 178 by 254 mm, with the optional 7 by 10-inch kit.
Jobs can also be printed on label stock, transparencies, precollated
stock, tab stock, carbonless paper, and other specialized stocks. The
printer engine monitors the print job so that, should a paper jam
occur, the job resumes on the correct page, at the correct tab, using
the same color, and so forth, providing complete document integrity.
SYSTEM OVERVIEW
1-7