Guidelines For Controller Placement; Controller Hardware Specifications And Requirements Summary - Xerox DocuPrint 100 Installation Planning Manual
Xerox docuprint 100: install guide
Hide thumbs
Also See for DocuPrint 100:
- Software manual (498 pages) ,
- Service manual (304 pages) ,
- Installation planning manual (242 pages)
Table of Contents
Advertisement
Controller requirements and specifications
Guidelines for controller placement
Controller hardware specifications and requirements summary
5- 4
all sides of the controller stand.
•
Adequate work space and service clearance around the
equipment
•
Proximity to electrical and network connectors
•
Security of the work area. You may need to place the system
in an area where you can restrict access to it.
To ensure consistent performance and avoid any damage to
equipment, follow these rules for placing the components of the
controller.
Do:
•
Use the controller stand that comes with your printing system
equipment.
•
Allow at least 6 inches / 152 mm of unobstructed space at the
front and rear of the processor, so the fan and vents are not
blocked.
The following illustration shows fan and vent locations on the
front and back of the processor.
Do not:
•
Place the monitor and processor on a desk or table top.
•
Do not place the monitor on top of the processor.
•
Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
•
Do not place the processor on its side, or in any other position
but the upright, vertical position achieved by using the
controller stand.
•
Do not place the processor or monitor on top of the printer.
For a summary of printer hardware specifications and
requirements, refer to the "Printer specifications and
requirements" chapter of this guide. Contact your local Xerox
representative if you have questions not specifically addressed in
this guide.
Installation Planning Guide
Advertisement
Table of Contents
