Maintenance; Recommended Maintenance Schedule(S) - Toro 41393 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
After the first 8 hours
After the first 50 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Yearly
Maintenance Procedure
• Replace the hydraulic-fluid filters.
• Torque the wheel-lug nuts.
• Change the rear planetary-gearbox fluid.
• Check the fan/alternator belt.
• Change the engine oil and oil filter.
• Check the fuel lines and connections.
• Pack the front wheel bearings.
• Check the tire air pressure.
• Check the brakes.
• Clean the suction strainer.
• Check the tank straps.
• Check the air cleaner.
• Check the engine oil.
• Check the coolant level.
• Check the hydraulic-fluid level.
• Lubricate the pump.
• Lubricate all grease fittings.
• Check the battery-cable connections.
• Lubricate the boom hinges.
• Replace the air-filter element.
• Torque the wheel-lug nuts.
• Inspect the condition and wear of the tires.
• Check the cooling-system hoses for wear and damage.
• Check the fan/alternator belt.
• Change the engine oil (including synthetic oil) and oil filter.
• Check front wheel toe-in.
• Inspect all hoses and connections for damage and proper attachment.
• Clean the radiator fins.
• Grease the actuator-rod bearings.
• Complete all yearly maintenance procedures specified in the engine operator's
manual.
• Check the fuel lines and connections.
• Replace the fuel-filter canister.
• Replace the in-tank fuel filter.
• Drain and clean the fuel tank.
• Pack the front wheel bearings.
• Change the planetary-gearbox fluid.
• Check the coolant (as directed by the manufacturer) and change if necessary.
• Replace the hydraulic-fluid filters.
• Change the hydraulic fluid.
• Inspect the O-rings in the valve assemblies and replace them if necessary.
• Change the pressure filter.
• Inspect the pump diaphragm and replace if necessary.
• Inspect the pump check valves and replace if necessary.
• Inspect the pivot bushings.
• Flush the sprayer with clean water.
• Calibrate the agitation-bypass valve.
48