Toro 41393 Operator's Manual page 77

5. Installing the Section-Manifold Valve (page
81)
6. Installing the Valve Actuator (page 82)
Removing the Valve Actuator
1. Position the sprayer on a level surface, set
the parking brake, stop the pump, shut off the
engine, and remove the key from the starter
switch.
2. Remove the retainer that secures the actuator
to the manifold valve for the section valve or
agitation valve (Figure
Note:
Squeeze the 2 legs of the retainer
together while pushing it down.
Note:
Retain the actuator and retainer for
installation in Installing the Valve Actuator (page
82).
Figure 99
Section-Valve Actuator Shown (the agitation valve actuator
1. Actuator (section valve)
2. Retainer
3. Remove the actuator from the manifold valve.
99).
is similar)
3. Stem port
Removing the Agitation-Manifold
Valve
1. Remove the clamps, gaskets, quick connect,
and quick-connect pin that secure the manifold
for the agitation valve to the agitation-bypass
valve, pressure-filter head, reducer coupling,
and adapter fitting (agitation-throttle valve) as
shown in
Note:
Retain the clamps, gaskets, quick
connect, and quick-connect pin for installation in
Installing the Agitation-Manifold Valve (page
1. Quick-connect pin
2. Flange (pressure-filter
head)
g032545
3. Manifold (agitation valve)
4. Flange (agitation-bypass
valve)
5. Flange (reducer coupling)
2. Remove the agitation-valve manifold from the
machine
1. Agitation-valve manifold
77
Figure 100.
Figure 100
Agitation Valve
6. Flange (adapter
fitting—agitation-throttle
valve)
7. Quick connect
8. Gasket
9. Flange clamp
(Figure 101).
Figure 101
81).
g032546
g032547