Specifications; Operation; Think Safety First; Performing Pre-Starting Checks - Toro 41393 Operator's Manual

InfoCenter Advisory Table (cont'd.)
Condition
Tank Status
Tank Status
Parameter Status
Parameter Status
Booms Turned Off

Specifications

Note:
Specifications and design are subject to
change without notice.
Base weight
Weight with standard spray
system, empty, without
operator
Weight with standard spray
system, full, without operator
Maximum gross vehicle weight
(GVW) (on level ground)
Tank capacity
Overall width with standard
spray system booms stored in
the X position
Overall length with standard
spray system
Overall length with standard
spray system to the top of the
booms stored in the X position
Overall height with standard
spray system
Overall height with standard
spray system to the top of the
booms stored in the X position
Ground clearance
Wheel base
Optional Equipment
The Toro Company has optional equipment and
accessories that you can purchase separately and
install on your sprayer. Contact your Authorized
Service Dealer for a complete list of optional
equipment that is currently available for your sprayer.
Code
402
403
502
503
802
1,307 kg (2,882 lb)
1,307 kg (2,882 lb)
2,499 kg (5,510 lb)
3,023 kg (6,665 lb)
1,135.6 L (300 US gallons)
226 cm (89 inches)
391 cm (154 inches)
442 cm (174 inches)
146 cm (57.5 inches)
231 cm (91 inches)
18.4 cm (7.25 inches)
198 cm (78 inches)
Qualifier
Low spray tank volume
Rinse pump active
Wrong parameter value entered
A value is outside the range of
accepted values
Speed dropped

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and
decals in the safety section. Knowing this information
could help you or bystanders avoid injury.
Performing Pre-Starting
Checks
Check the following items each time you begin use
of the sprayer for the day:
•
Check the tire pressure.
Note:
These tires are different than car tires; they
require less pressure to minimize turf compaction
and damage.
•
Check all fluid levels and add the appropriate
amount of specified fluids, if any are found to be
low.
•
Check the brake pedal operation.
•
Check to see that the lights are working.
•
With the engine off, check for oil leaks, loose parts,
and any other noticeable malfunctions.
If any of the above items are not correct, notify your
mechanic or check with your supervisor before taking
the sprayer out for the day. Your supervisor may want
you to check other items on a daily basis, so ask what
your responsibilities are.
35
Display Text
Tank status, volume low
Tank status, rinse pump on
Parameter status, invalid value
Parameter status, invalid data
defaults used
Booms turned off, stopped or
moving too slowly