Toro 41393 Operator's Manual page 19

1. Parking-brake pedal
2. Brake pedal
Brake Pedal
Use the brake pedal to stop or slow the machine
(Figure 8).
CAUTION
If you operate the sprayer with poorly adjusted
or worn brakes, you could lose control of the
sprayer, resulting in serious injury or death
to you or bystanders.
Always check the brakes before operating the
sprayer and keep them properly adjusted and
repaired.
Parking Brake
The parking brake is a pedal to the left of the brake
(Figure 8). Engage the parking brake whenever you
leave the seat to prevent the sprayer from accidently
moving. To engage the parking brake, press the
brake pedal, and, while holding the brake, press the
parking-brake pedal. To disengage, press and release
the brake pedal. If the sprayer is parked on a steep
grade, apply the parking brake and place blocks on
the downhill side of the wheels.
Ignition Switch
The ignition switch (Figure
the engine, has 3 positions: O
S .
TART
Speed-Lock Switch
The speed-lock switch locks the position of the traction
pedal at the time that the switch is set
ensures that the sprayer travels at a constant speed
while driving the machine on level ground.
Figure 8
3. Traction pedal
7), used to start and stop
, O /P
FF N REHEAT
(Figure
g032468
1. Center console
2. Speed-lock switch
Throttle Lever
The throttle lever, located on the control panel
between the seats
the engine. Push the lever forward to increase the
engine speed and pull it rearward to decrease the
engine speed.
Work-Light Switch
Toggle the switch to operate the work lights
7). Push it forward to turn the lights on and rearward
to turn them off.
Fuel Gauge
The fuel gauge on the dash of the machine and
displays the level of the fuel in the tank
, and
9). This
19
Figure 9
3. Throttle lever
(Figure 9), controls the speed of
(Figure
g032469
(Figure
7).