Toro 41393 Operator's Manual page 51

Installing the Engine-Heat Shield
1. Align the rear flange of the forward heat shield
over the forward flange of the rear heat shield
(Figure 59).
Figure 59
1. Front of the machine
2. Hex-head bolts and
washers
2. Align the holes in the forward heat shield with
the threaded holes in the chassis
3. Assemble the forward heat shield to the machine
with the 6 hex-head bolts and 6 washers
59) that you removed in step
Forward Heat Shield (page
4. Torque the bolts to 1,978 to 2,542 N∙cm (175
to 115 in-lb).
5. Remove the jack stands and lower the machine.
g028177
3. Rear flange (forward heat
shield)
4. Forward flange (rear heat
shield)
(Figure 59).
(Figure
3 of Removing the
50).
Removing the Seat-Base-Access
Panel
1. Remove the 2 flanged-head bolts that secure
the seat-base-access panel to the seat base
(Figure 60).
1. Seat-base-access panel
2. Flanged-head bolt
2. Remove the seat-base-access panel from the
machine (Figure
Installing the Seat-Base-Access
Panel
1. Align the holes in the seat-base-access panel
with the holes in the seat base
2. Assemble the seat-base-access panel to the
seat base with the 2 flanged-head bolts
60) that you removed in step
Seat-Base-Access Panel (page
3. Torque the bolts to 1,975 to 2,542 N∙cm (175
to 225 in-lb).
51
Figure 60
3. Hole (seat base)
60).
(Figure 60).
1 of Removing the
51).
g032998
(Figure