Toro 41393 Operator's Manual page 20

Sprayer Controls
1. Battery-voltage-warning light
2. Oil-pressure-warning light
3. Glow-plug-warning light
4. Coolant-temperature-warning light
5. Pressure gauge
6. Spray-mode switch
7. Tank-agitation switch
8. Right raise/lower-boom switch
Application-Rate Switch
The application-rate switch is located on the dash to
the right of the steering wheel
hold the switch forward to increase the application rate
(pressure), or press and hold it rearward to decrease
the application rate (pressure).
Pressure Gauge
The pressure gauge (Figure
dash. This gauge shows the pressure of the fluid in
the spray system in psi and kPa.
Master Boom Switch
The master boom switch is located on the center
console of the machine. It allows you to start or stop
the spray operation. Press the switch to enable or
disable the spray system
(Figure 10). Press and
10) is located on the
(Figure 10).
Figure 10
9. Right boom switch
10. Center boom switch
11. Left boom switch
12. Master boom switch
13. Left raise/lower-boom switch
14. Pump switch
15. Application-rate switch
Boom-Section Switches
The boom-section switches are located on the center
console in the front of the arm rest
each switch forward to turn the corresponding boom
section on and rearward to turn each off. When the
switch is in the O
InfoCenter.
Note:
These switches will only affect the spray
system when the master boom switch is in the O
position.
Pump Switch
The pump switch is located on the center console to
the right of the seat
forward to run the pump or rearward to stop the pump.
When the switch is turned on, a light on the switch
illuminates.
20
(Figure
position, an icon appears on the
N
(Figure 10). Toggle this switch
g032996
10). Toggle
N