Table of Contents
Advertisement
Windows 98 SE
This section includes:
■
Preliminary Steps
on page 3-11
Quick CD-ROM Install Steps
■
■
Other Methods of Installation
■
Windows 98 SE Troubleshooting
Preliminary Steps
Follow these preliminary steps:
1.
Verify that the printer is plugged in, turned on, and connected to an active network.
2.
Verify that the system is receiving network information by monitoring the LEDs on the
back of the device or on the CentreDirect External Print Server. When the system is
connected to a functioning network and receiving traffic, its link LED is green, and its
amber traffic LED is flashing rapidly.
3.
Print a Configuration page and verify that the desired protocol is enabled, and then follow
one of these options:
■
Proceed to Step 4 if you do not have a TCP/IP address configured for your system.
Proceed to Step 5 if you do have a TCP/IP address configured for your system.
■
4.
Do one of the following if you do not have a TCP/IP address configured for your
computer:
■
Contact your system administrator to ensure that configuration is made according to
your company guidelines.
■
Configure your computer with a unique address such as 192.1.1.1.
5.
If you have a TCP/IP address, follow these steps to verify the IP address for your
computer:
a.
Click Start, and then click Run.
b.
Enter winipcfg in the Open field. (If the file is not found, TCP/IP may not be
installed.)
c.
Click OK.
d.
Select your network adapter from the list. The IP address is listed in the IP Address
field.
Note:
For more information about installing and configuring TCP/IP in Windows
environments, go to your Microsoft Windows documentation.
6.
Proceed to Quick CD-ROM Install Steps or Other Methods of Installation for the
installation method desired.
See also:
Quick CD-ROM Install Steps
Other Methods of Installation
Phaser® 8510/8560MFP Multifunction Product
on page 3-12
on page 3-13
on page 3-15
on page 3-12
on page 3-13
3-11
Windows 98 SE
Advertisement
Table of Contents
Troubleshooting
