Xerox Phaser 8510MFP Advanced Features Manual page 72

Setting the Duration for the Tray 1 Prompt
The Tray 1 prompt setting specifies the amount of time the prompt displays on the control
panel after paper is loaded in the tray. The Tray 1 prompt requests that the user confirm the
current tray setup or specify the correct paper type and size for the print job.
Duration
None (Factory default setting)
30 Seconds
Infinite
To select a Tray 1 prompt setting, use one of the following options:
■ The system's control panel
■ CentreWare IS
Using the Control Panel
To select the Tray 1 prompt setting on the control panel:
1. Press the System button.
2. Select
General Setup
3. Select
Paper Handling Setup
4. Select
Tray 1 Prompt
5. Select the appropriate duration, and then press the OK button.
Using CentreWare IS
To select the Tray 1 prompt setting using CentreWare IS:
1. Launch your web browser.
2. Enter the system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then select Printer Defaults.
5. Select the appropriate setting in the Tray 1 Prompt drop-down list.
6. Click the Save Changes button at the bottom of the page.
Phaser® 8510/8560MFP Multifunction Product
Behavior
Turns the tray setup prompt off.
Displays the tray setup prompt for 30 seconds after paper is
loaded in Tray 1.
Displays the tray setup prompt after paper is loaded in Tray 1 until
a control panel selection is made. The system will not print until a
selection is made.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
4-11
System Settings