Xerox Phaser 8510MFP Advanced Features Manual page 67

Changing the Power Saver Timeout
To save energy, the system enters a Power Saver, low-energy consumption mode after a pre-
defined period of time since its last activity. In this mode, most electrical systems are shut
down. When a job is sent to the system, the system enters Warmup mode. You can also warm
up the system by pressing the OK button on the control panel.
If you find that the system is going into Power Saver mode too often and you do not want to
wait while the system warms up, increase the length of time before the system goes into Power
Saver mode.
To change the Power Saver Timeout value, use one of the following options:
The system's control panel
■
■ CentreWare IS
Using the Control Panel
To change the Power Saver Timeout value on the control panel:
1. Press the System button.
2. Select
General Setup
3. Select
System Controls
4. Select , and then press the OK button.
Power Saver
5. Press the Up Arrow or Down Arrow button to scroll to a selected Power Saver Timeout
value. Select a larger value if you want to extend the length of time before the system goes
into Power Saver mode.
6. Press the OK button.
Using CentreWare IS
To change the Power Saver Timeout value using CentreWare IS:
1. Launch your web browser.
2. Enter your system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then click Warmup.
5. Select a value from the Power Saver Timeout drop-down list.
6. Click the Save Changes button at the bottom of the page.
Phaser® 8510/8560MFP Multifunction Product
, and then press the OK button.
, and then press the OK button.
4-6
System Settings