Xerox Phaser 8510MFP Advanced Features Manual page 68

Changing Intelligent Ready Mode
Intelligent Ready mode is an automated system that:
■ Monitors the system's usage.
■ Warms up the system when you are most likely to need it based on past usage patterns.
■ Activates the Power Saver mode when the system times out.
To turn on/off the Intelligent Ready mode, use one of the following options:
The system's control panel
■
■ CentreWare IS
Using the Control Panel
To turn Intelligent Ready mode on/off on the control panel:
1. Press the System button.
2.
Select
General Setup
3. Select
System Controls
4.
Select Intelligent Ready
5. Press the OK button to turn on/off Intelligent Ready.
6. Select , and then press the OK button to return to the main menu.
Exit
Using CentreWare IS
To select Intelligent Ready mode or to schedule warmup/standby settings using
CentreWare IS:
1. Launch your web browser.
2. Enter your system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click Properties.
4. Select the General folder on the left sidebar, and then select Warmup.
5.
Select Intelligent Ready, Scheduled, or Job Activated from the Warmup Mode
drop-down list to change the setting.
6. If you selected Scheduled in Step 5, make selections for each day's warmup setting and
standby setting.
7. Click the Save Changes button at the bottom of the screen.
Note: Although the control panel selections only enable you to turn Intelligent Ready mode
on or off, CentreWare IS enables you to specify particular system Warmup modes and settings.
Phaser® 8510/8560MFP Multifunction Product
, and then press the OK button.
, and then press the OK button.
.
4-7
System Settings