Table of Contents
Advertisement
●
or to Rpgm then press the Menu Select button directly below Rpgm to send reprogram request to
the dispatcher.
The display shows Reprogram Rqst and Please wait.
Result:
If you hear five beeps, the dispatcher has acknowledged the reprogram request. The display shows Ack
received and the radio returns to the Home screen.
If the dispatcher does not acknowledge the reprogram request within six seconds, you hear a low-pitched
alert tone and the display shows No acknowledge. Try again or press
screen.
7.2.6
Dynamic Zone Programming
Dynamic Zone Programming (DZP) provides one or more Dynamic Zones to store frequently used channels
for conventional or trunking.
NOTE: Your radio must be programmed for you to use this feature. At least one zone in the radio must
be a nondynamic zone.
7.2.6.1
Entering the Dynamic Zone to Select a Dynamic Channel
Procedure:
1.
or to Zone then press the Menu Select button directly below Zone.
The display shows the Zone screen.
2.
or
to <# Dynamic Zone Channels>.
3. Perform one of the following actions:
●
Press the Menu Select button below Sel to select.
●
Press the Menu Select button below Exit to exit.
If you have selected one of the Dynamic Zone Channels list, the display returns to Home screen with
the selected <# Dynamic Zone Channels> shown on the screen.
If you have selected Exit without selecting any Dynamic Zone Channels list, the display returns to
Home screen without any changes.
7.2.6.2
Saving a Channel in the Dynamic Zone from List Selection
Prerequisites: To perform this operation, the radio must be in the Dynamic Zone.
Procedure:
1.
or to ZnPr. Press the Menu Select button directly below ZnPr to enter the Program Zone screen.
2
# indicates number of the channel on the 16-Position Switch which are numbered from 1 to 16.
to cancel and return to the Home
2
MN004476A01-AN
Chapter 7: Advanced Features
53
Advertisement
Table of Contents
