Plugging In The Electrode Plugs - Primedic HeartSave PAD Operating Instructions Manual

Operating the device and sequence of reanimation

7.8 Plugging in the electrode plugs

Fig. 12: Plugging in the electrode plugs
Procedure:
Note
Note
Operating instructions
32
Before positioning the electrodes on the patient, carry out the BLS actions as
instructed.
After the voice message asks you to < Plug in electrode cable >, insert the plug of
the electrode cable into the jack on the HeartSave PAD as shown in the diagram
above.
Make sure that the locking pin locks into place.
Once the electrodes are connected to the patient and the electrode plug is
plugged in, the BLS instructions are automatically interrupted.
To be able to unplug the electrode plug, you have to push firmly on the top
part of the locking pin while at the same time pulling the plug up.
HeartSave PAD 22289 / GB / C