Nokia IP500 Series Installation Manual page 97

To install the Nokia Encryption Accelerator II card:
1. Locate the PMC connectors on the motherboard.
2. Position the male PMC connectors on the card over the female PMC
connectors on the motherboard, as shown in part B of
The four screw holes and four standoffs should also be aligned with one
another.
Caution
If the IP500 Series appliance motherboard was built before May
2002, the standoff holes to the power connector will not line up. Do
not install the fourth screw into the misaligned standoff hole.You can
install three of the screws without affecting the operation of the
encryption accelerator card. The connectors should align with each
other.
3. Push down on the card until it is properly seated on the motherboard.
4. Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
IP500 Series Installation Guide
All manuals and user guides at all-guides.com
Installing the Nokia Encryption Accelerator II Card
Figure 33.
97