3
Configuring the Appliance
Figure 7 Sample System Startup Interface Selection Screen
Select an interface from the following
configuration:
1) eth1
2) eth2
3) eth3
4) eth4
5) quit this menu
Enter choice [1-5] :
1. To select an interface, enter the number that corresponds to the Ethernet
port connection that you connected the cable to in
Interfaces"
You use this interface to perform configuration tasks.
2. Enter the IP address for the interface you selected.
3. Enter the mask length.
4. Indicate whether to set the default route. The default is yes.
5. Depending on network characteristics, set the connection to 10 Mbps (the
default) or 100 Mbps.
6. Set the connection to half duplex (the default) or full duplex.
Confirming the Setup
When prompted, type N to change any of the information you entered. This
returns you to the menu in Step 4. When you finish changing entries, confirm
your entries by typing Y. This action returns you to the menu in
Step 4. Type 4 on this menu, to leave system startup.
38
All manuals and user guides at all-guides.com
on page 31.
"Connecting Network
IP500 Series Installation Guide