Automatic High Beams; If Equipped; Flash-To-Pass; Automatic Headlights - Jeep GRAND CHEROKEE 2023 Owner's Manual

50 GETTING TO KNOW YOUR VEHICLE
A H B —
UTOMATIC IGH EAMS
I E
F QUIPPED
The Automatic High Beam Headlight system provides
increased forward lighting at night by automating high
beam control through the use of a digital camera mounted
on the inside rearview mirror. This camera detects vehicle
specific light and automatically switches from high beams
to low beams until the approaching vehicle is out of view.
NOTE:
 The Automatic High Beam Headlight system can be
turned on or off by selecting or deselecting "Auto Dim
High Beams" within Uconnect Settings
 The headlight switch must also be turned to the AUTO
position after Automatic High Beams is enabled within
Uconnect Settings for the feature to activate.
 Automatic High Beams will only activate when the
vehicle speed is above 22 mph (35 km/h).
 Broken, muddy, or obstructed headlights and taillights
of vehicles in the field of view will cause headlights to
remain on longer (closer to the vehicle). Also, dirt, film,
and other obstructions on the windshield or camera
lens will cause the system to function improperly.
If the windshield or Automatic High Beam Headlight
Control mirror is replaced, the mirror must be re-aimed to
ensure proper performance. See a local authorized dealer.
F -T -P
LASH O ASS
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This will
cause the high beam headlights to turn on, and remain on,
until the lever is released.
A H
UTOMATIC
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
page 168.
Ú
rotate the headlight switch counterclockwise to the AUTO
position. When the system is on, the headlight time delay
feature is also on. This means the headlights will stay on
for up to 90 seconds after you place the ignition into the
OFF position. The headlight time delay can be
programmed 0/30/60/90 seconds within the Uconnect
system page 168.
Ú
To turn the automatic system off, move the headlight
switch out of the AUTO position.
NOTE:
The engine must be running before the headlights will
come on in the automatic mode.
EADLIGHTS
P L A P
ARKING IGHTS ND ANEL
To turn on the parking lights and instrument panel lights,
rotate the headlight switch to the first position. The
headlight switch is equipped with an AUTO and ON detent
but not an OFF detent. Headlights will be deactivated
when the headlight switch is placed in the parking lights
position. However, the Daytime Running Lights (DRLs) will
be activated along with the front and rear marker lights.
The DRLs may be deactivated when the parking brake is
engaged.
H O A
EADLIGHTS N UTOMATICALLY
W
IPERS
If your vehicle is equipped with Automatic Headlights, it
also has this customer-programmable feature. When your
headlights are in the automatic mode and the engine is
running, they will automatically turn on when the wiper
system is on. This feature is programmable through the
Uconnect system page 168.
Ú
NOTE:
When your headlights come on during the daytime, the
vehicle will monitor outside brightness and decide if the
instrument panel needs to be dimmed or not.
L
IGHTS
W
ITH