Connecting The Power Supply; Fuses For Supplementary Socket Outlets - Dräger Primus Instructions For Use Manual

Connecting the power supply
The mains voltage must correspond to that specified on the
rating plate at the back of the workstation.
Voltage range: 85 to 264 V.
@ Plug the mains plug into the wall socket.
LED »« on the front of the workstation lights up green.
Fuses for supplementary socket outlets
When using the twofold socket strip with automatic circuit-
breakers:
If a fuse is tripped (position 0):
@ Remedy the fault, then
@ Press the switch on the automatic circuit-breaker into
position I. The fuse is now active again.
When using the three-fold socket strip* with safety fuses:
@ Remedy the fault, then
@ have the safety fuse replaced by an electrician.
Only available in countries with socket outlets conforming
to DIN 49440
Instructions for Use Primus SW 2.n
Preparation
000
OO
|
31