Table of Contents
Advertisement
Cabling the Line Interfaces
Returns to Global Configuration Mode, from which you can enter the GigabitEthernet Interface
configuration mode for the remaining GBE port.
Repeat this procedure to configure auto-negotiation for the other GBE port interface.
Connect the GBE Line Interface Ports
Refer to
of your system.
Figure 5-3
The following table presents the fiber specifications. The SCE 1000 may be ordered with either
Multimode or Single Mode transceivers The transceiver type is indicated on the front panel under the
ports. Note that both transceivers on any individual SCE 1000 are the same, either 850nm Multimode
OR 1310 Single Mode.
Table 5-1
SCE Model
SCE 1000 2xGBE
MM
SCE 1000 2xGBE
SM
Plug the specified fiber optic cable (see table above) into the appropriate GBE port on the front panel of
Step 1
the SCE 1000.
Verify that the link LED is green.
Step 2
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
5-4
Information About Cabling, page 5-1
Cabling the GBE Interface
PW R A
PW R B
ST AT US
BY PA SS
MN G 1
MN G 2
CO NS OL
E
AU X
LIN K RX
LIN K/
10/ 100 /
TX
AC TIV E
LIN K/
100 0
10/ 100 /
AC TIV E
100 0
RX
MM
SU B
Fiber Specifications
Transceiver
850nm Multimode –9.5 to –4 dBm
1310nm FRP laser
Single Mode
to find the appropriate cabling diagram for the topology
C is c o S
C E 1 0 0 0
S er ie s
2 x G B E
LIN K RX
TX
TX
RX
MM
TX
GB E-1
LIN E
NE T
Transmit Power
–9.5 to –3 dBm
Chapter 5
Cable the Line Ports
Typical (Max.)
Receive Power
Distance
–17 to 0 dBm
•
750m for
50µm Core
Diameter
MMF
400m for
•
62.5µm Core
Diameter
MMF
–20 to 3 dBm
10 km for 9.0µm
Core Diameter
SMF
OL-7822-06
Advertisement
Table of Contents
